AccuQuilt Go! Square 2" (1.5" Finished) Die 55022

How to Cut 2" Squares

Cutting Mat Required: AccuQuilt GO! Fabric Cutting Mat 5"x10" 55110

For best cutting results, position fabric on the lengthwise grain (straight of grain) as it goes under the roller.

• Cut a 6 1/2" strip across the width of fabric.
• Fanfold into 4 1/2" widths.
• Place on selected blade and cut.
• Cut 48 squares across the width of fabric.
• One yard of 40" wide fabric cuts 240 squares.

Why Quilters Love the GO! 2" Square Die

• The smaller the square, the more difficult it is to cut accurately and the more squares you need. The GO! Square-2" makes it easy to cut (36) 1 1/2" finished squares in one pass through the cutter!
• No sliding rulers! No miscuts! The GO! Square-2" includes six squares that can be time-consuming to cut by hand.
• GO! Square-2" was designed as a companion square for the GO! Qube™ Mix & Match 6", 8", 10" and 12" sets (55775, 55776, 55797, 55778).
• The GO! Square-2" die is the perfect size to cut your own squares with your favorite fabrics or out of fabric pieces from your stash.
• GO! Square-2" includes 1/4" seam allowances for easy alignment and piecing.
• Cut squares out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more!
• A great way to use up scraps.
• Free pattern downloads available to get you started.
• Fat Quarter-friendly.

Dimensions

• Weight in lbs.: >0.88
• Cut Size: >2"W x 2"H (5.1 cm x 5.1 cm)
• Finished Size: >1 1/2"W x 1 1/2"H (3.8 cm x 3.8 cm)
• Die Board Size: >5 in. x 10 in. (12.7 cm x 25.4 cm)

AccuQuilt Benefits

• Cut so much more fabric in less time.
• Get accurate cuts every time -- No slipping rulers or mistakes
• Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
• Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut.
• Safe to use -- No blades come anywhere near your fingers

Die Tips

• With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors.
• Blades on some dies are positioned at an angle. Align fabric to edge of shape, not edge of die board.
• Use good quality fabric to reduce fabric stretch.
• It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.